Re: BlueSaab Amp pcb!

Posted by Seth on Nov 29, 2016; 1:25pm
URL: http://bluesaab-forum.90.s1.nabble.com/BlueSaab-Amp-pcb-tp737p838.html

sbt wrote

Seth wrote

BOM: http://www.mouser.com/ProjectManager/ProjectDetail.aspx?AccessID=7386d4e698

I note this BoM is currently missing a 2.2kΩ resistor for R14. For example, could use Vishay P/N CRCW08052K20FKEA or KOA Speer P/N RK73H2ATTD2201F.

If you built a v5.0 BlueSaab PCB, you might have some Vishay 2.2kΩ resistors left over, especially if you switched any LED resistors to 10kΩ.

Same applies to the legacy amp PCB.

Cheers,
Sam.

Just FYI, it hasn't been determined if R13/R14 are even necessary. I put a spot on the board for them just in case. (its easier to not populate shit vs add shit later)