Re: BlueSaab Legacy Amp PCB?
Posted by Seth on Nov 17, 2016; 3:54am
URL: http://bluesaab-forum.90.s1.nabble.com/BlueSaab-Legacy-Amp-PCB-tp785p811.html
So this is what I've come up with; it's just a tweak to the existing PCB amp v1.1, so I made it rev 1.2.
This just has some pads exposed on the bottom, which you will solder the pins on the CDC to, after some bending. (see pics below). Once you bend the 4 pins and the amp pcb is assembled, you solder 6 wires to the bluesaab pcb from the old cdc pin holes and 3.3v and gnd. then solder this amp pcb to the pins, upside down. then solder the 6 wires to the amp pcb. YOU WILL HAVE TO BEND THE PINS UP, OR BEND THE MCP2515 CRYSTAL OVER SO THE PCB CAN FIT.
URL: http://bluesaab-forum.90.s1.nabble.com/BlueSaab-Legacy-Amp-PCB-tp785p811.html
So this is what I've come up with; it's just a tweak to the existing PCB amp v1.1, so I made it rev 1.2.
This just has some pads exposed on the bottom, which you will solder the pins on the CDC to, after some bending. (see pics below). Once you bend the 4 pins and the amp pcb is assembled, you solder 6 wires to the bluesaab pcb from the old cdc pin holes and 3.3v and gnd. then solder this amp pcb to the pins, upside down. then solder the 6 wires to the amp pcb. YOU WILL HAVE TO BEND THE PINS UP, OR BEND THE MCP2515 CRYSTAL OVER SO THE PCB CAN FIT.
NC, USA
| Free forum by Nabble | Edit this page |