Re: How-to/tutorial?

Posted by homerisback on Mar 29, 2016; 8:11pm
URL: http://bluesaab-forum.90.s1.nabble.com/How-to-tutorial-tp106p307.html

My car is a 9-3 SE Convertible MY2002 with AS3 Audio system and CDC wires pre-installed.

Blue BT2 LED was flashing but not sure about BT1 red LED, however my Nexus 5 connected well to the RN52 chip. As this module is my first SMD attempt ever, I may have soldered the BT1 LED upside-down, because having difficulties to identify anode and cathode... But I don't think this could prevent Audiosystem to switch to CDC source, right ?
The power is constantly on and one CAN LED blinking fast while other CAN LED remaining off or very few times on (not sure about this one).
As written to Seth previously, my Tech2 reported a connected CDC, so the "status report" sendings over CAN seem working. The only odd behaviour is audiosystem which reports OK then missing alternatively (via Tech2), and as far as I remember, it didn't happen before the module connection (but not yet checked if back to normal when the module is disconnected).
Would swapped CAN wires jam the comms and prevent the radio to switch on CDC source ?

Anyway, thank you very much for this great job and help provided !!