Re: V6.1 assembly progress

Posted by Seth on Jan 16, 2020; 10:40am
URL: http://bluesaab-forum.90.s1.nabble.com/V6-1-assembly-progress-tp1570p1571.html

If you don’t populate R6-9 and R21-24, you probably won’t have any sound.

Other than that, it looks good 👍🏻

On Thu, Jan 16, 2020 at 00:04 1S2A1B [via BlueSaab Forum] <[hidden email]> wrote:

I've got the board populated, just waiting on the connector. Take a look and let me know if you spot any mistakes. Being new to the project the empty spots were concerning but I suspect they're remains from previous iterations. This was my first smd project, not so tough once you get into the rhythm for the lil guys.

I messed up with the ARM chip. I soldered a corner to hold it in place, but it was a little misaligned. Spent a while trying to wick and suck and pry it back up, or scoot it over, but just soldered more pins in the process. It was basically off by 1 pin in one direction. So I ripped each pin on 2 sides back up, and carefully bent it over to where it should be. There was a lot of cursing. You can see it in the photo, it looks like it's a camera angle but it's straight on. No big surprise if I've killed it, but I'm optimistic.

I appreciate the hard work you guys have put into this. Looking forward to powering it up.

2001 9-3 base

---

If you reply to this email, your message will be added to the discussion below:

http://bluesaab-forum.2349123.n4.nabble.com/V6-1-assembly-progress-tp1570.html

To start a new topic under Hardware, email [hidden email]
To unsubscribe from Hardware, click here.
NAML